Installing The Semg Module - Triton 4739 Manual De Usuario

SETUP

INSTALLING THE sEMG MODULE

NOTE: Model 4739 can be upgraded to become a traction unit with
sEMG by attaching a sEMG Module (P/N 4766) to the unit.
• Disconnect the traction unit from the power source before attempting
any maintenance, installation, removal, or replacement procedures to
prevent electrical shock and possible damage to the unit.
Turn the unit off. Disconnect the
traction unit from its power source.
Disconnect the Patient Interrupt
Switch from its receptacle.
Gently press the tabs underneath the
unit, pull and remove the front panel
from the traction unit
Patient
Interrupt Switch
Receptacle
24
FRONT VIEW
BACK VIEW
Connector
Gently push the sEMG Module into
the front of the traction unit. Once
the plastic of the unit and the module
are aligned, the connector should
be inserted properly, with the tabs
locked in place.
Plug the traction unit back into the
power source. Connect the Patient
Interrupt Switch and the sEMG lead
wire into the receptacles.Turn the
unit on.
The traction unit should automatically
recognize the sEMG Module with
the sEMG Traction button now being
active on the Home Screen.
Triton® Traction
sEMG
Lead Wire
Receptacle