Retrieving Data From Existing Patient Data Card - Triton 4739 Manual De Usuario

OPERATION

RETRIEVING DATA FROM EXISTING PATIENT DATA CARD

Existing Patient Data Card Use
Insert the Patient Data Card (with the
gold chip facing up) into Patient Data
Card port located on the front of the
traction unit.
Press the Clinical Resources button on
the front of the traction unit.
Press the Patient Card (Patient's Name)
button located in the Patient Card
section of the menu.
NOTE: If the Patient Data Card is not
inserted, this button is
deactivated.
45
Triton® Traction
The treatment list is located on the
right side. Press the Up or Down Arrow
button to select the desired treatment.
Press the Return Arrow to accept. This
will show the following information:
Before and After Treatment Pain
Information (Pain Map, Pain Scale and
Pain Type) and Session Notes.
NOTE: The box located on the left
side of the treatment list is a
review of treatment parameters
of the selected treatment.
The review of the treatment
shows the following information:
Patient's Name, Date, Start
Treatment Time, End Treatment
Time, Treatment Parameters and
Session Notes (stored on card
via PC only).
Press Run This Treatment button.
Read and follow the steps of the
Patient Preparation section on Pages
28-29 to set up traction treatment.
Press the Start button to begin
treatment.