Technical Data - geberit ACO 201 Instrucciones De Servicio

Automatic pressing function
LED indicator
Stop button
Signal tone
Standby mode

Technical data

16
Operating instructions ACO 201
An automatic pressing function ensures that the pressed joint is
completely finished. For safety reasons, the automatic pressing
function is not activated until a certain press capacity has been
attained (after approx. two seconds). Following this, the pressing
operation takes place automatically and can only be interrupted by
pressing the stop button.
The two LEDs show the operating statuses of the pressing tool:
• Green LED lights up: The pressing tool is ready for operation
• Green LED flashes: Fault
• Red LED lights up or flashes: Fault
In the event of a malfunction, please see the "Troubleshooting"
chapter.
The stop button has two functions:
• Switching off the motor
• Cancelling the malfunction indicator
A signal tone sounds six times in case of malfunctions or if the
pressing has not been completed correctly.
If the pressing tool is not used for about one hour, it switches over to
standby mode automatically. The LEDs are switched off. The
pressing tool can be restarted by pressing the start button for
about two seconds.
Nominal voltage
Power input
Nominal force
Net weight
Noise level at user's ear
Vibration value
Temperature range during operation
Ampere-hour capacity
14.4 V DC
375 W
32 kN
3.1 kg
68 dB(A)
≤ 2.5
m/s²
-20 °C - +60 °C
2.4 Ah