Publicidad
en-us | 50 | T40344/8
8.
Attach the transmission support to the workshop
crane as described in the workshop manuals and
operating instructions.
WARNING
Risk of a falling load!
Attaching the transmission support to the
workshop crane incorrectly could cause the load to
tilt or fall. This could result in serious injuries and
severe damage to materials.
Fasten the transmission support to the
workshop crane exactly as described in the
workshop manuals.
Observe the operating manuals of the
respective accessories used.
Ensure that the transmission support T40344A
is correctly installed before lifting the load.
9.
Attach the transmission support to the engine and
transmission trestle VAS 6095 or VAS 6095A as
described in the workshop manuals and operating
instructions.
WARNING
Risk of a falling load!
If the transmission support is not attached to the
engine and transmission trestle correctly, the load
may swivel or slip! This could result in serious
injuries and severe damage to materials.
Ensure that the support flange is completely
inserted in the hollow shaft of the engine and
transmission trestle.
Ensure that the transmission support is secured
to the hollow shaft with a ball lock pin.
Only remove the ball lock pin when the
transmission is attached to the workshop crane
with the transmission support.
CAUTION
Crushing hazard!
Risk of crushing between the load and
VAS 6095/VAS 6095A when moving the load.
Position hands and feet in such a manner that
crushing hazards do not exist when moving the
load.
10. Move the transmission to the desired working
height and working position.
11. Carry out further work as described in the
workshop manuals.
2019-06-27
12. Ensure that all parts of the special tool have been
removed after completing the repair work.
13. Store the transmission support and the bolt in a
suitable location.
Bosch Automotive Service Solutions GmbH
Am Dörrenhof 1
85131 Pollenfeld-Preith
Germany
Publicidad
Capítulos
