Publicidad
en-us | 49 | T40344/8
2 General Safety Instructions
WARNING
Read and follow all safety notes and instructions!
Failure to follow the safety instructions could result in
serious injuries and severe damage to materials.
Observe and follow the safety notes below.
The load holding device has been specifically
constructed for its intended use. The safety of the
load holding device can no longer be ensured if it is
misused or modified in ways not expressly approved
by the manufacturer. Serious personal injuries or
severe damage to materials could occur.
Ensure that each person using the load holding
device is familiar with these instructions and can
access them at all times.
Ensure that all users are also familiar with the
instructions of the additional tools and workshop
equipment that are necessary for the work.
Carefully read and adhere to the instructions in the
technical safety information of the Volkswagen
Group brands.
Use all available safety mechanisms on the
transmission support.
Wear safety shoes (in accordance with
ISO 20345, S2).
Wear protective gloves in order to avoid cuts.
Position hands and feet so as to avoid potential
crushing hazards.
Use the load holding device only for work approved
by the Volkswagen Group.
Use the load holding device only with the
accessories approved by the Volkswagen Group.
Do not exceed the maximum load capacity of
220 kg.
Persons may not be under the load or in the hazard
area while the load is being moved.
Do not work on suspended loads.
2019-06-27
3 Operating Instructions
1.
Inspect the bolt for visible damage before each
use. Do not use the bolt when defects have been
detected and discard it immediately.
2.
Prepare the transmission support T40344 or
T40344A as described in the operating
instructions.
3.
Remove the bolt (3) from the transmission support
and store it in a safe place (see Figure 1).
4.
Attach the bolt T40344/8 to the transmission
support and tighten it with a torque of 20+5 Nm.
NOTICE
Damaging the transmission in the attachment
point!
If the bolt is not tightened correctly on the
transmission support, the transmission may be
damaged.
Always tighten the bolt with the specified
torque.
Only screw the bolt with a calibrated torque
wrench.
Do not glue the bolt with loctite.
5.
Insert the bolt T40344/8 and (5) in the attachment
holes in the transmission as described in the
workshop manuals.
6.
Insert both set screws in the holes on the opposite
side and screw them in with the star knobs (4) until
the stop.
7.
Ensure that the support surfaces of the set screws
(4) and the bolt T40344/8 and (5) fit against the
housing edge of the support hole in the
transmission.
WARNING
Risk of a falling load!
Attaching the transmission support to the load
incorrectly could cause the load to tilt, swivel, or
fall. This could result in serious injuries and severe
damage to materials.
Fasten the transmission support to the load
exactly as described in the workshop manuals
in order to prevent the load from falling.
Before lifting the load, ensure that the set
screws and bolts on the transmission are in
place.
Bosch Automotive Service Solutions GmbH
Am Dörrenhof 1
85131 Pollenfeld-Preith
Germany
Publicidad
Capítulos
