Table 3-3 Pipe Configuration Option List Definitions - Siemens SITRANS F Serie Guia De Inicio Rapido

Commissioning
3.4 Setting the Parameters
Select Pipe Configuration
1. Trigger <Left Arrow> and then <Down Arrow> to select [Pipe Configuration].
2. Trigger <Right Arrow> sensor.
3. Trigger <Up/Down Arrows> to select a configuration that approximates the conditions
4. Trigger <ENTER> to save selection. The [Anomaly Diams] menu will appear.
5. Trigger <Right Arrow> to select "=" sign.
6. Trigger <Up/Down Arrows> to select number of pipe diameters.
7. Trigger <ENTER> to save selection.
8. To return to the top menu level, continue to trigger the <Left Arrow>.
Table 3-3 Pipe Configuration Option List Definitions
Options
Fully Developed
1 Elbow
Dble Elbow+
Dble Elbow-
Valve
Expander
Reducer
Norm Entry
Header Inlet
Intrusions
26
upstream of your transducer mounting location. (Refer to the definitions below.)
① Use this menu cell to select the pipe configuration that most accurately represents the
upstream pipe condition.
② Use this menu cell to enter the number of pipe diameters between the upstream configuration
and the transducer installation.
Definitions
Fully developed flow, as would be expected for very long
straight pipe runs or installation downstream of a flow
condition.
Single 90 degree Elbow upstream of transducer installation.
Double out-of-plane Elbows upstream of transducer
installation.
Double in-plane Elbows upstream of transducer installation.
Not available at this time.
Pipe expansion upstream of transducer installation.
Pipe reduction upstream of transducer installation.
Not available at this time.
Header or pipe manifold upstream of transducer installation.
Not available at this time.
Operating Instructions, 12/2008, CQO:QSG002 Revision B
FUS1010 IP65 NEMA 4X Quick Start