Setting The Parameters; Important - Siemens SITRANS F Serie Guia De Inicio Rapido

3.4

Setting the Parameters

Flowmeter Programming
Note
Before creating a site select English or metric units from the Meter Facilities menu.
Select a Meter Type
1. After power-up, use the Magnetic Wand to trigger the <ENTER> sensor and access the
2. Trigger the Right Arrow> sensor.
3. Trigger <Up/Down Arrows> to select [2 Channel Flow]
4. Trigger <ENTER> sensor to select meter type: [Channel 1 Clamp-on] appears.
5. To select [Channel 1 Clamp-on] mode, trigger <Right Arrow> sensor.
6. Trigger <ENTER> sensor to select mode. [Channel Setup] menu will appear.
FUS1010 IP65 NEMA 4X Quick Start
Operating Instructions, 12/2008, CQO:QSG002 Revision B
top level of the Installation Menu.
Note
Select [2 Channel Flow] if measuring two different pipes and [Dual Path Flow] if sensors
are mounted on the same pipe.
① Top level of Installation Menu
② ENTER Sensor
Note
IMPORTANT: Colon appears when menu item is selected for entry.
③ ENTER Target Symbol Sensor
④ Current Selection
Commissioning
3.4 Setting the Parameters
23