Sony SDM-P246W Manual Del Usuario página 44

4 Press the m/M buttons to select the desired mode
and press the OK button.
• ON: Make the appropriate adjustments of the screen's
phase, pitch and horizontal/vertical position for the
current input signal and store them.
Note
When the monitor is turned on or the input signal is
changed, AUTO ADJUST makes the automatic
adjustments.
• OFF: AUTO ADJUST is not available.
Note
AUTO ADJUST works automatically when the input
signal is changed.
x Adjust the picture's sharpness and position
manually (PITCH/PHASE/H CENTER/
V CENTER) (for INPUT3 only)
You can adjust the picture's sharpness as follows. This
adjustment is effective when the computer is connected to the
monitor's HD15 input connector (analog RGB).
1 Set the resolution to 1920 × 1200 on the computer.
2 Load the CD-ROM.
3 Start the CD-ROM
For Windows User
When Auto run operates:
Select the area, language and model, and click DISPLAY
ADJUSTMENT TOOL (UTILITY).
4 Click "Adjust" and confirm the current resolution
(top value) and recommended resolution (bottom
value), and then click "Next".
Test pattern for PITCH appears.
5 Press the MENU button.
The main menu appears on the screen.
6 Press the m/M buttons to select
press the OK button.
The SCREEN menu appears on the screen.
7 Press the m/M buttons to select PITCH and press the
OK button.
The PITCH adjustment menu appears on the screen.
8 Press the m/M buttons until the vertical stripes
disappear.
Adjust so that the vertical stripes disappear.
9 Press the OK button.
The main menu appears on the screen.
If horizontal stripes are observed over the entire screen, adjust
the PHASE using the following procedures.
10 Click "Next".
11 Press the m/M buttons to select PHASE and press
12 Press the m/M buttons until the horizontal stripes
13 Press the OK button.
14 Click "Next".
15 Press the m/M buttons to select H CENTER or V
16 Press the m/M buttons to center the test pattern on
17 Click "Next".
When Auto run fails to operate:
1
(SCREEN) and 2
3
For Macintosh User
1
2
3
4
5 Press the m/M buttons to select
17
(GB)
Test pattern for PHASE appears.
the OK button.
The PHASE adjustment menu appears on the screen.
are at a minimum.
Adjust so that the horizontal stripes are at a minimum.
The main menu appears on the screen.
Test pattern for CENTER appears.
CENTER and press the OK button.
The H CENTER adjustment menu or V CENTER adjustment
menu appears on the screen.
the screen.
Click "End" or "EXIT" to turn off the test pattern.
Open "My Computer" and right click the CD-ROM
icon.
Go to "Explorer" and open the CD-ROM icon.
Open [Utility] and then select [WINDOWS].
Start [WIN_UTILITY.EXE].
Test pattern appears. Go to step 4.
Open the CD-ROM.
Open [Utility] and then select [MAC].
Open [MAC UTILITY] and then start
[MAC_CLASSIC_UTILITY] or [MAC_OSX_UTILITY].
Test pattern appears. Go to step 4.
Press the MENU button.
The main menu appears on the screen.
press the OK button.
The SCREEN menu appears on the screen.
(SCREEN) and