Setup 4: Adjust The Tilt And Height - Sony SDM-P246W Manual Del Usuario

Setup 4: Adjust the tilt and height

Adjust the position of the monitor
This monitor can be adjusted within the angles shown below.
Grasp the sides of the LCD panel, then adjust screen
angles.
approx. 5°
approx.
175°
approx.
25°
approx. 175°
Adjust the height of the monitor
1 Remove the stopper-pin from the stand.
Note
Do not remove the stopper pin while the stand is laid. It may fall or injure
you by the stand neck coming off the stand base impetuously.
2 Hold both sides of the LCD display, and then adjust
the display height.
To use the monitor comfortably
Adjust the viewing angle of your monitor according to the height
of your desk and chair, and so that light is not reflected from the
screen to your eyes.
Notes
• When adjusting the screen tilt, proceed slowly and carefully, being sure
not to hit the monitor against the desk.
• When you adjust the angles of the display, be careful not to get your
fingers caught between the stand and the display.
• Do not put any objects under the display when you adjust the height of
stand. It may get damaged by accident.
10
(GB)
Stopper-pin
approx. 70 mm
3
(2 / inches)
4