Assembly And Initial Start-Up - Kärcher K2 Follow Me Cordless Manual Del Usuario

zle acts on the high-pressure gun. Keep
proper footing and hold the high-pressure
gun and spray lance firmly. Accidents or
damage due to the device falling over. Be-
fore all actions with or on the device, you
must make sure that it is stable.
ATTENTION Do not operate the device at
temperatures below 0 °C.
Operation with detergent
WARNING Incorrect use of deter-
gents can cause serious injuries or poison-
ing.
CAUTION Keep the detergent out of
the reach of children. Only use the deter-
gents supplied or specified by the manufac-
turer. The use of other detergents or
chemicals can impair the safety of the de-
vice.
Care and service
WARNING Always pull out the mains
plug before all care and maintenance work.
CAUTION Have repair work and work
on electrical components carried out by the
authorised customer service only.
ATTENTION Do not use acetone, undilut-
ed acids or solvents, as they corrode the
materials used on the device.
ATTENTION
Danger of frost
Incompletely emptied devices can be de-
stroyed by frost.
Completely empty the device and accesso-
ries.
Protect the device from frost.
Transportation
CAUTION Risk of accidents and inju-
ries. Take into account the weight of the de-
vice for transportation and storage. See
chapter Technical data in the operating in-
structions.

Assembly and initial start-up

Note
 The battery is partially charged at the
time of delivery.
 Please charge the battery before initial
start-up and when required. For more in-
formation, see section Charging the bat-
tery.
See the illustrations on the fold-out page to
install the appliance.
1. Place the appliance on the even surface.
2. Unplug the clamp for the high-pressure
hose from the trigger gun.
Illustration B
3. Connect the high-pressure hose to the
trigger gun.
Illustration C
4. Push the clamp into the trigger gun until
fixed into place.
5. Ensure that the high-pressure hose is
securely connected to the trigger gun by
pulling the high-pressure hose.
6. Insert the spray lance into the trigger
gun, and turn the spray lance by 90° to
lock it.
Illustration D
7. Connect the high-pressure hose to the
high-pressure connection located on the
appliance.
Illustration E
Water connection
Note
 Contamination in the water can damage
the pump and the accessories.
 Only fill the tank with clear water.
1. Open the cover of the water tank, and
pull the water tank straight up.
Illustration F
2. Fill the tank with clear water.
Illustration G
3. Close the cover.
4. Place the water tank on the appliance.
English 23