Troubleshooting; Troubleshooting Guide; Warranty - Kärcher K2 Follow Me Cordless Manual Del Usuario

Frost protection
Note
Completely drain the appliance and acces-
sories, and protect the appliance and ac-
cessories against frost.
1. Completely drain all water from the ap-
pliance:
a Switch on the appliance with the high-
pressure hose and water supply dis-
connected (max. 1 minute).
b Switch off the appliance until no more
water exits at the high-pressure con-
nection.
2. Store the appliance and all accessories
in a frost-free room.

Troubleshooting

Troubleshooting guide

Malfunctions often have simple causes that
you can remedy yourself using the follow-
ing overview. When in doubt, or in the case
of malfunctions not mentioned here, please
contact your authorised Customer Service.
Troubleshooting
Before doing any work on the appliance:
1. Switch off the appliance.
2. Disconnect the battery charger.
Appliance is not running
1. Pull on the lever of the trigger gun to
switch the appliance on.
2. Switch the appliance off via the "ON /
OFF" switch. Wait a few seconds, and
switch the appliance on again.
3. Check the charging status of the battery.
4. If the temperature of the motor or battery
is hot, please wait for it to cool down.
26
Appliance does not have sufficient
1. Appliance ventilation:
a Disconnect the high-pressure hose.
b Switch the appliance on, and operate
the appliance (max. 2 minutes) until
the water exits the high-pressure con-
nection without bubbles.
c Switch the appliance off.
d Reconnect the high-pressure hose to
the appliance.
2. Pull out the sieve from the water connec-
tion using flat-nose pliers, and clean the
filter under the running water.
Strong pressure fluctuations
1. Check the water level in the water tank.
2. Clean the high-pressure nozzle:
a Remove the dirt / dust from the nozzle
bore using a needle.
b Apply water to the front of the nozzle
bore to rinse it through.
Appliance is leaking
 Slight leakage from the appliance pump
is normal. If the leakage increases,
please contact the next authorised cus-
tomer service site.
Battery in not charging.
 The temperature of the motor or battery
is hot. Wait for it to cool down.
The warranty conditions issued by our rele-
vant sales company apply in all countries.
We shall remedy possible malfunctions on
your appliance within the warranty period
free of cost, provided that a material or
manufacturing defect is the cause. In a war-
ranty case, please contact your dealer (with
the purchase receipt) or the next author-
ised customer service site.
(See overleaf for the address)
English
pressure

Warranty