Atco Balmoral 14 S Instrucciones De Operación página 16

EURO • Printed in England • BA F016 L69 831 • Balmoral • GB • OSW 10/01
F016 L69 832 - Buch Seite 4 Donnerstag, 25. Oktober 2001 8:31 08
Stopping
E
Move the throttle lever 7 to position
E
Engaging Cylinder cutter and rear roller
1. Start engine.
2. Push the red safety latch 22 forward and gradu-
ally squeeze the cutter control lever 9 towards
the top handle 1.
3. Gradually squeeze the drive control lever 8 to-
wards the top handle 1.
4. Release the safety button 22.
5. Adjust the speed as required by moving the
throttle lever 7 between
To stop, release both control levers 8 and 9.
Engaging rear roller only
1. Start engine.
2. Gradually squeeze the drive control lever 8 to-
wards the top handle 1.
3. Adjust the speed as required by moving the
throttle lever 7 between
4. To stop, release the drive control lever 8.
Engaging Cutters only
1. Start engine.
2. Push the red safety latch forward and gradually
squeeze the cutter control lever 9 towards the
top handle 1.
3. To stop, release the cutter levers 9.
Mowing
Before mowing, check the engine oil level and fill
the petrol tank.
Toward the end of season, it is advisable to put only
as much fuel in the tank as you need for each cut,
since it should be completely used before storing
the mower.
G
For best results, place the lawnmower on the
edge of lawn, mow in a forward direction figure.
Then at right angles at the end of each turn, slightly
overlapping the previously cut strip.
The next time you mow the lawn, try to work at right
angles to the previous cut as this will help prevent
unevenness in the surface soil which can build up if
you always mow in the same direction.
16 • F016 L69 831 • TMS • 18.10.01
.
Note: To ensure long and reliable service, carry out
the following maintenance regularly.
Regularly check for obvious defects such as a
loose, dislodged or damaged blade, loose fixings,
and worn or damaged components.
Check that covers and guards are undamaged
and correctly fitted. Carry out necessary mainte-
nance or repairs before using.
and .
Clean the exterior of the machine thoroughly using
a soft brush and cloth. Do not use water, solvents or
polishes. Remove all debris, especially from the air
filter and engine fins.
If the mower should happen to fail despite the care
taken in manufacture and testing, repair should be
carried out by an authorised customer service
agent for Atco-Qualcast garden products.
and .
For all correspondence and spare parts orders, al-
ways include the 10-digit part number from the
nameplate of the machine!
C D
The cutter should be adjusted if the grass is not cut
cleanly and evenly.
1. Tilt the mower back and wedge securely.
2. Remove grassbox cradle 23.
3. Turn adjuster bolt 24 clockwise a little at a time.
Note: The blades are correctly adjusted when the
cutting cylinder 25 lightly brushes the bottom
blade 25 across the full width as the cylinder is
turned.
The blade act like a pair of shears, as a test, cor-
rectly adjusted blades will cut a piece of good
quality writing paper across the width of the blade.
Once correctly adjusted refit grassbox cradle 23.
- 4
English
Maintenance
Stop and remove spark plug cap.
Adjusting the Blade