Declaration Of Conformity - Atco Balmoral 14 S Instrucciones De Operación

EURO • Printed in England • BA F016 L69 831 • Balmoral • GB • OSW 10/01
F016 L69 832 - Buch Seite 7 Donnerstag, 25. Oktober 2001 8:31 08
Guarantee
Atco-Qualcast guarantees this product against
manufacturing defects. We will repair (or replace
at our option) if a manufacturing defect occurs
within the guarantee period as long as it has not
been subjected to rental/hire use. The engine fit-
ted to this mower is covered by the engine manu-
facturer. See engine manual for details.
The guarantee period for domestic use is 3 year for
parts (1 year engine + extend guarantee option of
one further year, see engine manual for details)
and 1 year for labour costs from date of purchase.
For the purpose of this guarantee:
Non-domestic use means all other uses including,
commercial, income producing, but excluding
rental/hire use.
To obtain a repair under this guarantee:
– Take your lawnmower to a Atco-Qualcast Ap-
proved Service Agent.
– Show your dated proof of purchase.
– Show the guarantee page.
This guarantee does not apply if:
– the product has been resold by original pur-
chaser (this does not apply in the Republic of Ir-
land), or has been used under hire.
– the product has been modified to cange the
manufacturer's specification, or if non-genuine
spares have been fitted.
– if any previous repair was undertaken by any-
one other than an Atco-Qualcast Approved
Service Agent.
– the fault is due to maladjustment, abuse, ne-
glect or accidental damage.
– the fault is due to lack of lubrication or mainte-
nance.
Blades, drive chains, bearings, rubber on the rear
roller and cables.
The cost of routine maintenance of the product is
not covered by the guarantee.
It is in your best interest to follow the Operating In-
structions for your mower/scarifier, as a properly
cared for product should give many yeas of excel-
lent service.
Should you require spare always insist on genuine
Atco-Qualcast spares. Any damage caused to the
product through the fitting of parts not made or
approved by Atco-Qualcast is not covered by the
Guarantee.
Your statutory rights are not affected by this guar-
antee.
19 • F016 L69 831 • TMS • 18.10.01
Your product has been manufactured under an
environmental management system using where
possible the most environmentally responsible ma-
terial and processes, and with the potential for re-
cycling at the end of its life.
When the time comes to dispose of this product
please consider the environmental and take it to
recognised recycling facility.
(Please contact your Local Authority for location in-
formation.)

Declaration of Conformity

Measured values
2000/14/EC (1.60 m height, 1 m distance away)
and EN 25 349.
Typically the A-weighted noise level of the product
is: sound pressure level 81 dB (A) 14 S, 82 dB (A)
14 SE, 81 dB (A) 17 S, 82 dB (A) 17 SE, 83 dB (A) 20 S,
82 dB (A) 20 SE; sound power level 92 dB (A) 14 S,
93 dB (A) 14 SE, 92 dB (A) 17 S, 93 dB (A) 17 SE,
94 dB (A) 20 S, 93 dB (A) 20 SE.
The typical weighted acceleration is 4 m/s
We declare under our sole responsibility, that this
product is in conformity with the following stand-
ards or standardization documents: EN 60 335,
EN 836 according to the provisions of the directives
89/336/EEC, 98/37/EC, 2000/14/EC.
2000/14/EC: The guaranteed sound power level
L is lower than 95 dB (A) 14 S, 95 dB (A) 14 SE,
Wa
93 dB (A) 17 S, 95 dB (A) 17 SE, 95 dB (A) 20 S,
95 dB (A) 20 SE. Conformity assessment procedure
according to Annex VIII.
Notified body: SRL, Sudbury England
PLACE: Stowmarket, Juli 2001
Signature:
- 7
English
determined according
2
.
Position: Director
to