Publicidad
Step 5
Turn six BLACK 9/16" FLAT HEAD SCREWS (32S) into the
å
MODESTY PANELS (G and O) until the shoulders of the SCREWS
rest on the surface of the MODESTY PANELS.
NOTE: Do not overtighten the SCREWS.
å
Slide the SHORT MODESTY PANEL MOLDINGS (S) onto the
å
MODESTY PANELS (G and O). Line up the groove in the MOLDING
over the heads of the SCREWS in the MODESTY PANELS.
NOTE: If the MOLDINGS come up off of the SCREWS, remove
å
them and slide them on again.
Be sure these edges
are even after the
MOLDING is slid on.
S
Page 10
O
Be sure these edges
are even after the
MOLDING is slid on.
G
419956
Some assembly
(and snacks) required.
BLACK 9/16" FLAT HEAD SCREW
(6 used in this step)
Apply pressure with your hands as you
guide the MOLDINGS over the SCREWS
and onto the ENDS, UPRIGHTS, and BACKS.
S
Shoulder
Apply pressure with your hands as you
guide the MOLDINGS over the SCREWS
and onto the ENDS, UPRIGHTS, and BACKS.
32S
Shoulder
www.sauder.com/services
Publicidad
