Publicidad
Step 11
Separate the WIDE EXTENSION SLIDES (DD) from the WIDE EXTENSION RAILS (CC) as shown in the upper diagram
å
below. Be prepared, the parts are greasy.
Fasten the WIDE EXTENSION RAILS (CC) to the LEFT ENDS (B) and LEFT UPRIGHTS (E). Use four GOLD 5/16" FLAT
å
HEAD SCREWS (3S) through holes #1 and #3.
NOTE: For each WIDE EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the WIDE EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the ENDS and UPRIGHTS.
Turn a SCREW into this hole.
NOTE: The WIDE EXTENSION SLIDES will be used later for the LARGE DRAWERS.
å
Push the black lever in and pull the SLIDE from the RAIL.
Edge with
TWIST-LOCK®
FASTENERS
P
Open end
Page 16
Separate the WIDE EXTENSION SET (CC and DD)
from the NARROW EXTENSION SET (EE and FF).
DD
B
3
CC
2
1
CC
H
E
4
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
419956
CC
1
2
3
4
www.sauder.com/services
Open end
Publicidad
