Publicidad
Step 4
Turn the ENDS (A and B), UPRIGHTS (D and E), and BACKS (F) over.
å
Turn twelve BLACK 9/16" FLAT HEAD SCREWS (32S) into the ENDS (A and B),
å
UPRIGHTS (D and E), and BACKS (F) until the shoulders of the SCREWS rest on the
surfaces of the ENDS, UPRIGHTS, and BACKS.
NOTE: Do not overtighten the SCREWS.
å
Slide the MOLDINGS (I) onto the ENDS (A and B) and UPRIGHTS (D and E). Slide the
å
MOLDINGS (K) onto the BACKS (F). Line up the grooves in the MOLDINGS over the
heads of the SCREWS in the ENDS, UPRIGHTS, and BACKS.
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
å
The MOLDINGS should be centered over the ENDS, UPRIGHTS, and BACKS.
F
K
www.sauder.com/services
F
E
I
B
I
K
BLACK 9/16" FLAT HEAD SCREW
(12 used in this step)
D
A
419956
32S
I
I
Apply pressure with your hands as you
guide the MOLDINGS over the SCREWS
and onto the ENDS, UPRIGHTS, and BACKS.
Shoulder
Shoulder
Page 9
Publicidad
