Publicidad
Step 38
Step
Insert the GROMMET (10P) and GROMMET CAP (1P) into the large hole in the TOP (X).
å
To insert the KEYBOARD SHELF (M) into your unit, tip the front of the KEYBOARD SHELF down and drop the rollers on
å
the KEYBOARD SHELF behind the rollers on the unit. Lift the front of the KEYBOARD SHELF up and slide it into the unit.
NOTE: Before inserting the drawers, be sure the INNER CARTRIDGE in the EXTENSION RAILS on your unit is all the way
å
forward. The INNER CARTRIDGE should click into place against the BLACK TAB.
To insert the drawers into your unit, line up the EXTENSION SLIDES on the drawer with the EXTENSION RAILS on the unit
å
and push the drawers into the unit until the drawers are fully inserted. The drawers will push in hard until they are all the
way in, then they will slide in and out easier.
Push the RUBBER SLEEVES (2R) over the METAL PINS (1R). Insert the METAL PINS into the hole locations of your choice
å
in the RIGHT END (A) and RIGHT UPRIGHT (D). Set the ADJUSTABLE SHELF (T) onto the METAL PINS.
Push a CAM COVER (33P) onto each HIDDEN CAM.
å
Click the inner cartridge into place against the black tab.
Front
Black tab
1P
10P
www.sauder.com/services
Inner cartridge
70 lbs.
X
20 lbs.
35 lbs.
To cover HIDDEN CAMS
Extension Rail
Place the roller on the SLIDE
behind the roller on the RAIL.
50 lbs.
20 lbs.
M
25 lbs.
D
BOTTOM
40 lbs.
33P
(3 used)
419956
T
(4 used)
1R
2R
A
Page 43
Publicidad
