Publicidad
Step 6
Flip the the MODESTY PANELS (G and O) over.
å
Turn eight BLACK 9/16" FLAT HEAD SCREWS (32S) into the MODESTY PANELS (G and O) until the shoulders of the
å
SCREWS rest on the surfaces of the MODESTY PANELS.
NOTE: Do not overtighten the SCREWS.
å
Slide the LONG MODESTY PANEL MOLDINGS (L) onto the MODESTY PANELS (G and O). Line up the groove in the
å
MOLDING over the heads of the SCREWS in the MODESTY PANEL.
NOTE: Be sure the MOLDINGS are positioned exactly as shown. If the MOLDINGS come up off of the SCREWS, remove
å
them and slide them on again. The MOLDINGS should be centered over the MODESTY PANELS.
BLACK 9/16" FLAT HEAD SCREW
(8 used in this step)
Be sure these edges
are even after the
MOLDING is slid on.
www.sauder.com/services
Be sure these edges
are even after the
32S
MOLDING is slid on.
O
L
L
G
Apply pressure with your hands as you
guide the MOLDINGS over the SCREWS
and onto the ENDS, UPRIGHTS, and BACKS.
419956
Angled edge
Shoulder
Apply pressure with your hands as you
guide the MOLDINGS over the SCREWS
and onto the ENDS, UPRIGHTS, and BACKS.
Angled edge
Shoulder
Page 11
Publicidad
