Elcometer 480 Guia Del Usuario página 8

4 GETTING STARTED (continued)
4.7 SETTING UP THE READING DISPLAY
The colour LCD display is split into two halves; Top Display and
Bottom Display. The user can define which information is displayed in
each half including:
None; No information is displayed.
Ÿ
Readings; Sometimes referred to as 'Simple Mode', the
Ÿ
measurement readings are displayed for the geometries selected
- see Section 4.8 'Geometry Selection' on page en-8.
Selected Statistics; As defined by the user via Display/Statistics/
Ÿ
Select Statistics. Select from:
B & T: Number of readings, Mean,
Standard Deviation;
T: Highest Reading, Lowest
Reading, Range, Coefficient
of Variation, Nominal Value,
High Limit Value, Number
Above Limit, Low Limit Value,
Number Below Limit
The user can choose to view only
those selected or view all. The
statistics are displayed for the
geometry indicated at the top left of
the display (a).
Pressing the 8 softkey scrolls through the statistics for the
different geometries selected - see Section 4.8 'Geometry
Selection' on page en-8.
Run Chart (T); A line trend graph of the last 20 measurements
Ÿ
which is updated automatically after each reading. Pressing the
8 softkey scrolls through the chart for the different geometries
selected - see Section 4.8 'Geometry Selection' on page en-8.
Bar Graph (T); an analogue representation of the current gloss,
Ÿ
‡
haze or % reflectance value together with the highest (Hi), lowest
(Lo) and average (
automatically when each reading is taken. Pressing the 8
softkey scrolls through the bar graph for the different geometries
selected - see Section 4.8 'Geometry Selection' on page en-8.
‡
Model dependent: Dual and Triple Angle models only.
en-7
R
) reading. The graph is updated
X
Selected Statistics
a
www.elcometer.com