Elcometer 480 Guia Del Usuario página 9

4 GETTING STARTED (continued)
Readings & Differential (T);
Ÿ
last readings (c) are displayed for the
geometries selected (b) - see Section
4.8 'Geometry Selection' on page
en-8, together with the variation from
the nominal values set against the
Limit Standard (d) - see Section 5
'Limit Standards' on page en-9.
To setup the display:
1 Press Display/Setup Display/Top Display (or Bottom Display
as required).
é
2 Use the
'Select'.
If 'None' is selected for one half and 'Readings' or 'Run Chart' for the
other half, the readings or run chart will fill the whole the screen. If any
other combination of options is selected; the data will be shown in the
top or bottom display as specified.
4.8 GEOMETRY SELECTION
The Elcometer 480 Model B measures gloss at 60° only. The
Elcometer 480 Model T measures gloss at 20° , 60° and 85° , Haze
and % Reflectance at 20° , 60° and 85° . For an explanation of terms -
see Section 17 'Glossary' on page en-27.
Readings for a maximum of three geometries can be displayed at any
one time however, readings for all geometries are stored in the batch /
statistics and are transferred to ElcoMaster for further analysis.
To select which geometries are displayed:
1 Press Display/Display Geometry.
é
2 Use the
'Select'.
If three options are already selected, one must be de-selected before
another can be chosen.
‡
Model dependent: Dual and Triple Angle models only.
a
Not available in 'Scan Mode' - see Section 8.1 'Selecting the Measurement Mode' on page en-15.
www.elcometer.com
a
softkeys to highlight the required option and press
ê
‡
softkeys to highlight the required option(s) and press
ê
Readings & Differential
The
b
‡
‡
®
R
c
d
‡ ‡
en-8