Screen Settings - Elcometer 480 Guia Del Usuario

4 GETTING STARTED (continued)
4.4 SWITCHING THE GAUGE ON AND OFF
To switch on:
To switch Off:
4.5 SELECTING YOUR LANGUAGE
1 Press Menu/Setup/Language and select your language using
é
the softkeys.
ê
2 Follow the on screen menus.
To access the language menu when in a foreign language:
1 Switch the gauge OFF.
2 Press and hold the left softkey and switch the gauge ON.
3 Select your language using the

4.6 SCREEN SETTINGS

A number of screen settings can be defined by the user via
Menu/Setup/Screen Settings including:
Screen Brightness; This can be set to 'Manual' or 'Auto' -
Ÿ
the brightness is adjusted automatically using the gauge' s
ambient light sensor.
Screen Timeout; The display will go 'black' if inactive for 15, 30,
Ÿ
45 or 60 seconds as defined by the user. Press any key, or tap
the gauge to awaken it.
Screen Rotation; Using the internal accelerometer, the gauge
Ÿ
rotates the display to allow the user to measure or read values
at 0° or 180° orientation as selected. If 'Auto Display Rotation' is
selected, the gauge will automatically rotate the display.
www.elcometer.com
Press the measure softkey for approximately 3
seconds until the Elcometer welcome screen is
displayed.
Press 'Menu' and use the
'Power Off'. The gauge can also be set to switch
off automatically after a user defined period of
inactivity via Menu/Setup/Gauge Auto Off. The
default setting is 5 minutes.
é ê
softkeys to select
é
softkeys.
ê
R
en-6