A - SAFETY INSTRUCTIONS
In our efforts to continually improve our products,
we reserve the right to make any changes to the
technical, functional, or aesthetic characteristics
related to their development.
This motorised gate, and its manual, were
designed to enable a gate to be motorised in
compliance with current European standards.
WARNING
Important safety instructions. A motorised gate
is a product that can cause injury to people and
animals and damage to property. It is important for
people's safety to follow these instructions.
Keep these instructions.
1 - OPERATING PRECAUTIONS
• This apparatus may be used by children over
the age of 8 and by persons with reduced
physical, sensory or mental abilities or lack of
experience or familiarity, if they are correctly
supervised or if the instructions relating to the
safe use of the apparatus have been given to
them and the possible hazards are understood.
Children must not play with the device. Cleaning
and user maintenance must not be conducted
by children without supervision.
• This apparatus should only be used for its
intended purpose, that is, to motorise a one- or
two-panel gate for vehicle access. Any other use
will be considered dangerous.
• The opening or closing manoeuvre control must
be used with perfect visibility of the gate. Should
the gate be outside the user's field of vision, the
installation must be protected by a photocell
type safety device, and its operation must be
checked every six months.
• All potential users must be instructed in the use
of the motorised gate by reading this manual. It
must be ensured that no persons who have not
been instructed in the use of the device may set
the gate into motion.
• Before setting the gate into motion, ensure that
there is no person in the area in which the gate
moves.
• Do not let children play with the gate control
devices. Keep the remote controls out of the
reach of children.
• Avoid any natural obstacles (branch, stone, high
grass, etc.) impeding the gate's movement.
• Do not manually activate the gate when the
motor drive is not disengaged from the gate.
Avidsen cannot be held liable for any use that does
not comply with the instructions in this manual and
causes damage.
EN
4
2 - INSTALLATION PRECAUTIONS
• Read this entire manual before starting the
installation.
• The electrical installation of the motorised gate
must meet current standards (NF C 15-100) and
should be undertaken by a qualified person.
• The 230VAC mains supply must be protected
against surges with a suitable circuit breaker
which meets current standards.
• All electrical connections must be performed
with the power switched off (safety switch in the
OFF position) and battery disconnected.
• Ensure that crushing and shearing between
the mobile parts of the motorised gate and
the surrounding fixed parts due to the gate's
opening/closing movement are avoided or
signalled on the installation.
• The motorised part must be installed on a gate
according to the specifications provided in this
manual.
• The motorised gate must not be installed in
an explosive atmosphere (presence of gas,
flammable smoke, etc.).
• The installer must check that the temperature
range shown on the motor drive is suitable for
the location.
• The wire that acts as an antenna must remain
inside the electronic panel.
• It is strictly forbidden to modify any of the
components provided in this kit, or to use an
additional component not provided for in this
manual.
• During installation, but above all during
adjustment of the motorised gate, you must
ensure that no person, including the installer, is
in the area in which the gate moves at the start
and throughout the duration of
adjustment.
• The flashing light is an essential safety
component.
• If installation does not correspond to one of the
cases shown in this manual, you must contact
us so that we can provide all the components
necessary for smooth installation with no risk of
damage.
• After installation, ensure that the mechanism
is correctly adjusted and that the protection
systems work correctly.
The Avidsen company shall not be responsible in
case of damage if installation is not conducted as
indicated in these instructions.