Control Parts (Optional); Backup Battery (Optional Ref 580293); Solar Power Kit (Optional Ref. 114373) - Avidsen V300 Manual De Instrucciones

2 sets of photocells
Photocell RX1
Photocell RX2

6.5 - CONTROL PARTS (OPTIONAL)

Note:
These control parts must be normally open dry contacts.
push button, intercom
output.

6.6 - BACKUP BATTERY (OPTIONAL REF 580293)

The backup battery is useful in case the power is cut and it enables you to operate the motor drive for
several days.
• Cut off the 230V power supply (safety switch to the OFF position) and connect the battery to the BAT
terminal.
• Put the 230V power supply back on (safety switch to the ON position).
• The battery will load in 24 hours approximately. Beyond this time, test the gate's operation (1 opening +
1 closing) after having switched the motor drive off (safety switch in the OFF position).
• After this test, reconnect the power supply (safety switch to the ON position). The battery will take over
if the power is cut.

6.7 - SOLAR POWER KIT (OPTIONAL REF. 114373)

Refer to the solar kit instructions.
~- ~+ NO COM NC
~- ~+ NO COM NC
+ -
BAT TRANS
C - INSTALLATION
Photocell TX1
~- ~+
+ -
Photocell TX2
~- ~+
BAT TRANS
21 EN