Warnings; Opening/Closing; Type Of Command; Operating Modes - Avidsen V300 Manual De Instrucciones

E - OPERATION

1 - WARNINGS

A motorised gate is a product that can cause injury
to people and animals and damage to property. Our
motorised gate as well as its installation and user
guides were designed to remove all hazardous
situations.
Avidsen cannot be held liable for any installation or
use that does not comply with the instructions and
causes damage.
It is essential to read the instructions carefully
before using your motorised gate and to keep
these instructions for any later use.
General Safety Obligations
• This device is not intended for use by children or
persons with reduced physical, sensory or mental
abilities or lack of experience or familiarity, unless
they are supervised by someone responsible
for their safety or have been provided prior
instructions concerning the use of the device.
Children should be supervised to make sure that
they do not play with the device.
• All potential users must be instructed in the use
of the motorised gate by reading this user guide.
• No untrained person (child) must set the gate in
motion using the fixed (key selector) or portable
(remote control) devices.
• Prevent children from playing near or with the
motorised gate.
• Do not deliberately stop the moving gate,
except of course with a control device or for an
emergency stop.
• Prevent any natural obstacles (branches, stones,
high grass, etc.) from hindering the gate's
movement.
• Do not manually operate the gate when the
motors are not disassembled.
• Before setting the gate into motion, ensure that
there is no person in the area in which the gate
moves (children, vehicles, etc.).
• In the event of a malfunction, remove the
actuators from the gate mounting brackets to
allow passage and contact your installer. Do not
attempt to fix the product yourself.
• Do not alter or add components to the system
without discussing it with the installer.
EN 32

2 - OPENING/CLOSING

The gate can be controlled from a programmed
remote control, a programmed wireless code
keypad or a wired control device.

2.1 - TYPE OF COMMAND

There are two types of command to manoeuvre
the gate:
Gate control
Pedestrian control (by radio only)
• The gate control controls the opening, stopping
and closing of both panels.
• The pedestrian control is used to control the
opening, stopping and closing of the panel driven
by motor M1.
• The pedestrian control can also be used to stop
the two panels.
• The pedestrian control cannot be used to close
M1 if M2 is not fully closed.
• Automatic closure and photocells are not active
for pedestrian control.
• The pedestrian control does not work in collective
mode.

2.2 - OPERATING MODES

The operating mode is set by following the
instructions in the "operating mode" section.

2.2.1 - "SEMI-AUTOMATIC CLOSING" MODE

Description of operation from the closed gate
position:
To open the gate
• Activate the gate control.
• The flashing light will flash (1 flash per second).
• 1 second later, panel M1 starts opening.
• 2.5 seconds later, panel M2 starts opening.
• Both panels open up to their opening stop.
• When both panels have reached their opening
stop, the flashing light will stop flashing and the
manoeuvre will be complete.