Changing The Assist Level; Resetting Recorded Data; Switching The Display On And Off; Deleting All Data - Bosch Dtive Unit Speed Manual Original

Unidad motriz/ ordenador de control
Tabla de contenido

Publicidad

4.1.3 Changing the assist level

Increase power assist
The following assist levels are displayed one by one when
you press the button for selecting a more powerful assist
level: "NO ASSIST / no assistance", "ECO / low assist level",
"STANDARD / medium assist level", "HIGH / high assist
level", followed once again by "NO ASSIST / no assistance".
This means that the assistance increases each time you
press the button until you reach the highest power level.
If you subsequently press the button, the assistance
switches off.
Reduce power assist
If you press the button that reduces the assist level, the
assistance reduces each time the button is pressed and
returns to the most powerful assist level when it reaches
the end of the loop.
In the "NO ASSIST / no assistance" mode, you ride the bike
normally without the assistance of the motor.

4.1.4 Resetting recorded data

If you press the selector button for the display panel for
longer than three seconds with the control panel switched
on, this resets the trip, average speed and top speed to
zero. You cannot delete the total journey length using this
method.

4.1.5 Switching the display on and off

The back-lit display and LCD control panel display can
also be switched on even if the drive is not enabled. To
do this, press the button that switches the lights on. The
drive remains in "NO ASSIST / no assistance" mode. Now
you cannot change the assist level.
If you press the light button when the control panel is
switched on, the back-lit display turns on.
If you press the light switch when the light is on, the back-
lit display turns off. The power assist is still available and
you can change the assist level.

4.1.6 Deleting all data

Press the display ("Mode") selector button and the button
that deletes all data on the rear of the control panel at the
same time to delete all the data stored, including the total
journey length. The display then automatically switches
to settings mode for language, LCD contrast and wheel
circumference.
II User Manual Fast Pedelec
11

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido