Changing The Collet Chuck; Notes On Working With Materials/Tools/Speed Range - Parkside PDFW 120 A1 Traducción Del Manual De Instrucciones Original

♦ Use the combination spanner
collet chuck mount
♦ Fit the tool and screw the collet chuck mount
back into place.
♦ Release the black collar

Changing the collet chuck

You can change the collet chuck
diameter of the tool you want to use is different.
♦ Push the black collar
the flexible shaft
that the collet chuck mount
anticlockwise direction. Hold the black collar
in this position.
♦ Use the combination spanner
collet chuck mount
Unscrew the collet chuck mount
♦ Remove the collet chuck
a collet chuck with the desired diameter.
♦ Replace the collet chuck mount
flexible shaft . Screw the collet chuck mount
tight using the combination spanner
♦ Release the black collar
Using the work arbor for cutting discs
♦ Use the screw driver side of the combination
spanner to undo and tighten the screw of the
work arbor for cutting discs
♦ Fit the work arbor for cutting discs
described into the flexible shaft
♦ Use the combination spanner
screw on the work arbor for cutting discs
♦ Fit the desired cutting disc
screw between the two washers.
♦ Use the combination spanner
screw on the work arbor for cutting discs
PDFW 120 A1
to undo the
on the flexible shaft
.
if the shaft
all the way back onto
to lock the spindle. Note
is loosened in an
to undo the
on the flexible shaft
.
and replace it with
back on the
.
.
.
as
.
to undo the
/ onto the
to tighten the
Use the work arbor for polishing felts
.
♦ Screw the tip of the work arbor for polishing
felts clockwise into the corresponding hole
in the polishing felts
♦ Fit the work arbor for polishing felts
described into the flexible shaft
Using the work arbor for abrasive belts
♦ Push the required abrasive belt
pletely onto the corresponding work arbor for
abrasive belts
♦ Use the combination spanner
screw on the work arbor
abrasive belts.
♦ Fit the work arbor for abrasive belts
.
described into the flexible shaft
Notes on working with materials/
tools/speed range
■ Never use the appliance for other purposes
and only use original parts/accessories. Using
attachments or accessory tools other than those
recommended in the operating instructions can
lead to a risk of injury.
■ Determine the rotational speed range for work-
ing on zinc, zinc alloys, aluminium, copper and
lead by trying it out on test pieces.
■ Use a low rotational speed for work on plastics
and materials with a low melting point.
■ Use a high rotational speed for working on
wood.
■ Carry out cleaning, polishing and buffing work
.
in the medium speed range.
The following are recommendations only and not
binding. When carrying out practical work, carry
out your own tests to see which tool and which set-
tings are ideal for the material you are working on.
.
/ .
as
.
/ com-
/ .
to tighten the
/ to fasten the
/
.
GB │ IE │
as
33 ■