Publicidad
Idiomas disponibles
Idiomas disponibles
The first Vibrolux appeared in the mid 1950's as a
medium-sized combo amp. Throughout the years,
many new versions were issued, each with a dis-
tinct tone and personality, yet all remaining very
"Fender."
Power output of these early versions
ranged from 22 to 40 watts, lending them to good
use as small club or recording amps.
In the spirit of all the great Vibrolux amps of yester-
day, we offer the "Custom" Vibrolux Reverb of
today. It is not a reissue of any of the old units,
rather, it is a new amplifier with much of the sound
and "feel" of many great Fender amps of the past.
A. NORMAL CHANNEL INPUT 1 - Plug-in connec-
tion for instruments.
B. NORMAL CHANNEL INPUT 2 - Plug-in connec-
tion for instruments providing 6dB less gain than
input 1.
C. NORMAL CHANNEL VOLUME CONTROL -
Adjusts the overall loudness of the NORMAL
CHANNEL.
D. TREBLE CONTROL - Adjusts the high frequency
level of the NORMAL CHANNEL.
E. BASS CONTROL - Adjusts the low frequency
level of the NORMAL CHANNEL.
• NOTE: The BRIGHT CHANNEL provides extra
treble boost, especially at low volume settings.
F. BRIGHT CHANNEL INPUT 1 - Plug-in connec-
tion for instruments.
G. BRIGHT CHANNEL INPUT 2 - Plug-in connec-
tion for instruments providing 6dB less gain than
input 1.
H. BRIGHT CHANNEL VOLUME CONTROL -
Adjusts the overall loudness of the BRIGHT
CHANNEL.
F
e
n
d
e
r
V
i
b
F
e
n
d
e
r
®
V
i
b
®
The "Custom" Vibrolux Reverb was created for the
player who requires a medium powered amplifier
with very "vintage" tube tones. It is equipped with
all-tube reverb, very different from "spring reverb"
and all-tube "direct-coupled ocillator" vibrato
unique to this vintage of amplifier. Unlike many vin-
tage amps, the Vibrato and Reverb effects work in
both channels.
Vibrolux Reverb are the same Jensen P-10 10"
speakers used in the 1950's.
footswitch provided will switch ON/OFF both the
Vibrato and the Reverb.
It is suggested that you read this manual thorough-
ly to understand all the features and functions of
your new amplifier.
F
r
o
n
t
P
a
F
r
o
n
t
P
a
I. TREBLE CONTROL - Adjusts the high frequency
level of the BRIGHT CHANNEL.
J. BASS CONTROL - Adjusts the low frequency
level of the BRIGHT CHANNEL.
K. REVERB CONTROL - Adjusts the REVERB
effect level of both channels. The footswitch can
be used to switch ON/OFF the REVERB effect.
L. VIBRATO SPEED CONTROL - Adjusts the speed
of the VIBRATO effect.
M. VIBRATO INTENSITY CONTROL - Adjusts the
intensity of the VIBRATO effect. The footswitch
can be used to switch ON/OFF the VIBRATO
effect.
N. PILOT LAMP - Illuminates while the CUSTOM
VIBROLUX REVERB is ON. Should the light fail,
disconnect the power cord, unscrew the red
jewel and replace with a type T47 light bulb.
4
r
o
l
u
x
r
o
l
u
x
®
®
The speakers in the "Custom"
n
e
l
n
e
l
The 2 button
Publicidad
