Hach TitraLab AT1000 Serie Manual Básico Del Usuario página 15

This is only applicable to instruments with two syringes installed.
It is recommended to install the applications (refer to
installing the titrant. Applications using titrant from syringe 1 are loaded on line 1 of the home
screen (refer to Home screen
on line 2. After the applications are installed, the correct titrant can be connected to the applicable
syringe.
Optional: Fill a desiccant cartridge with an applicable desiccant. Put the desiccant cartridge into the
adapter on the titrant bottle cap. Refer to the illustrated steps that follow, step 1.
Loosen the tube connector on the bottle cap. Push the inlet tube through the connector. Make sure
that the end of the tube is at the bottom of the bottle. Tighten the connector on the bottle cap.
Use the same procedure to connect the second titrant bottle if a second syringe is installed on the
instrument.
Refer to the "Application Note" on the USB applications key to identify the correct pump to connect to
the reagent bottle. Refer to the illustrated steps that follow.
N O T I C E
on page 17) and applications using titrant from syringe 2 are loaded
Install the applications on page 19) before
English 15