Hach TitraLab AT1000 Serie Manual Básico Del Usuario página 18

Section 7 Startup
Chemical exposure hazard. Obey laboratory safety procedures and wear all of the
personal protective equipment appropriate to the chemicals that are handled. Refer to
the current safety data sheets (MSDS/SDS) for safety protocols.
Personal injury hazard. Never use the instrument without the syringe cover installed.
7.1 Configure the instrument
1. From the main menu, select Settings.
2. Select an option, then push Select.
Option
Applications
Operators
Date + Time
Brightness
Sounds
Language
Network
Legacy settings
Info
Restore Defaults Sets the instrument to the default configuration.
Options
Security
3. Push Back.
18 English
C A U T I O N
C A U T I O N
Description
Changes, makes copies, exports and removes application data. Make sure
that the duplication function does not make more than five applications for
each syringe installed.
Adds, changes and removes operators.
Sets the instrument date and time.
Sets the brightness of the display.
Sets the sound options.
Sets the language.
Give a name to the instrument. This name is used to connect the instrument
to a PC. If a printer is connected, this name is printed on the hard-copy
output. Restart the instrument if the name is changed.
Specify the sensor data when the legacy adapter is used.
Shows information about the instrument and the attached hardware.
Sets the application parameters view to expert mode. When the instrument
is set to off, sets the syringe to empty into the titrant bottle. Changes the
temperature display unit. Prints the measurement and derivative curves if a
printer is connected. Specify if a balance is connected. Specify if a propeller
stirrer is connected.
Change the password and specify which options are password protected.