Installing Your Wine Cabinet; Commissioning Your Cabinet - Eurocave Tete a Tete Modo De Empleo

Unpacking
•
Check, when your cabinet is delivered, that it does not have any external
faults (impact, warping...).
•
Open the door and check the integrity of the inside of your appliance
(walls, Main du Sommelier supports, hinges, bottle support...).
If there is a problem, contact your EuroCave dealer.
Installation
Transport your cabinet to the chosen location.
It must:
•
be open on the outside to allow air to circulate (not a closed
cupboard...)
•
not be too damp (laundry room utility room, bathroom...),
•
have a stable, flat floor,
•
have a power supply (standard socket, 16 A, earthed with circuit
breaker, 30 mA* (*not applicable to some countries).
1. Connection
Have your plug checked (presence of fuses, amps and 30 mA
circuit breaker).
Do not plug several cabinets into a multi-socket.
1I. Description
D2
D1 D3
D1
Oxygen extraction ON/OFF key.
Key backlighted if ON
D2
Lighting ON/OFF key. Key backlighted if ON
D3 Key for setting the temperature of the top of the
cabinet
D4
Key for setting the temperature of the bottom of
the cabinet
D5
Temperature display
5 - i
nstAlling your Wine cABinet
6 - c
ommissioning your cABinet
D5
D4
Precautions
•
Do not place your cabinet in an area likely to be flooded.
•
Do not position your cabinet near to a source of heat or expose it to
the effects of direct sunlight.
•
Prevent water from splashing on the entire rear section of the appliance.
•
Position your appliance so that there is a minimum space of 5 – 10 cm
between the wall and the rear wall of your cabinet.
•
The glass plate must never come into direct contact with the work
surface.
•
If you are positioning your cabinet under a work surface, leave a
minimum space of 2 cm all around the appliance including under the
work surface. Allow for a ventilation grill on the work surface
(recommended).
•
Arrange the power lead so that it is accessible and does not come into
contact with any component of the appliance..
•
Slightly tilt the cabinet backwards to adjust the front feet (adjusted by
screwing or unscrewing), so that you can level your cabinet (use of a
spirit level is recommended).
•
Remove the protective elements inside your cabinet.
III. Temperature settings
The EuroCave Tête à Tête cabinet is a multi-temperature cabinet.
When first starting up, the display indicates a temporary temperature.
All temperature setting is carried out from the control panel located on
the door.
1
Press one of the 2 temperature setting keys (top or bottom) of the
cabinet, depending on your choice, for approximately 5 seconds.
The display starts to flash.
Set the temperature, degree by degree, by successively pressing the key.
2
When you have reached the desired setting, stop pressing and wait for
the display to return to its initial status.
The value on the display is the actual temperature inside the
cabinet, it is therefore necessary to wait before your new setting
takes effect.
It is normal for the top glass plate to be hot. Ensure
that you do not place any object sensitive to heat on
this plate.
9
GB