SPORTSTECH ESX600 Manual De Usuario página 40

Step 3:
Sub-step 1:
First remove the hexagon head screws (37), semicircular washers (36) and the spring washers (6),
which are already pre-assembled on the frame. Make a note of where you took them, as they will be
re-mounted on the frame in sub-step 3.
Sub-step 2:
Join the armrest cover (18) with the corresponding cover end (17) and pull it over the armrest attach-
ment (3) before you connect the connector (15) to the lower part of the cable line (34).
Sub-step 3:
Now take the previously removed hexagon head screws (37), semicircular washers (36) and spring
washers (6) and put them back in the designated places. Finally, lower the armrest cover (18) to cover
the open joint and thus the visible screws.
40