SATA paint set 10 Instrucciones De Servicio página 180

Operating Instructions SATA FDG
EN
into the hub.
■ Insert the O-ring [17‑4] in the gland [17‑5].
■ Screw the gland in so that the agitator shaft can be turned by hand
without applying force.
■ Push the pneumatic motor [17‑1] and flex coupling [17‑2] onto the
agitator shaft.
■ Tighten the grub screw in the lower half of the coupling.
■ Tighten the flex coupling with the agitator shaft into the holder [17‑18].
■ Push the collet [17‑15] with the washer [17‑17] onto the agitator shaft
up to the hub.
■ Tighten the grub screw [17‑16] in the collet.
■ Push the agitator blade [17‑12] onto the agitator shaft and tighten the
grub screw [17‑11] in the collet [17‑14] over the agitator crossbeam
[17‑10] (see chapter 11.5).
■ Screw the hex nut [17‑13] onto the agitator shaft and tighten.
■ Tighten the hex screw [17‑8]
■ Secure the hex screw with the lock nut [17‑7].
■ Mount the cover with pneumatic agitator without gear on the material
pressure tank.
■ Close the material pressure tank (see chapter 10.4).
SATA paint set 10 with pneumatic agitator with gear and
SATA FDG 24 / 48 with pneumatic / electric agitator with gear
Disassembly:
■ Open the material pressure tank (see chapter 10.4).
■ Remove the cover with pneumatic / electric agitator with gear.
■ Loosen the lock nut [18‑10] and the hex screw [18‑11].
■ Remove the pneumatic motor with gear [18‑1] and the upper half of the
coupling [18‑2].
■ Remove the coupling washer [18‑3].
■ Loosen the grub screw [18‑19] in the collet [18‑18] under the hub
[18‑12].
■ Push the collet with the washer [18‑20] down to the bottom of the agita-
tor shaft [18‑6].
SATA FDG 24 / 48 with pneumatic / electric agitator with gear only
■ Unscrew the hex nut [18‑16] from the agitator shaft.
■ Take the agitator blade [18‑15] from the agitator shaft and loosen the
grub screw [18‑14] in the collet [18‑17] over the agitator crossbeam
[18‑13] (see chapter 11.5).
180