Switching On The First Time; Suggestions - Franke CRYSTAL CR 86 M F Serie Manual De Instalación Y Servicio

Horno multifunción
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 79
CL 85 M / CM 85 M / CR 86 M _/F / SM 86 M _/F / SMP 86 M_/F
During duration or end time adjustment
mode selection, the corresponding Auto
symbol flashes.
Once a programme duration
is set, the end time cannot
be decreased. Likewise, the duration
of a programme cannot be prolonged
once the end time is set.
Programme run
When the automatic programme
is in progress (and therefore
the cooking function is active),
the Auto symbol remains lit
and the remaining cooking time
appears on the display in countdown
form. The symbol
Automatic programme end
At the end of the programme duration
or when the end time is reached,
the corresponding symbol
At the end of the automatic programme,
the Auto symbol flashes, the display
shows "End" and an intermittent
acoustic signal (which can be stopped
by pressing Set) sounds.
Timer function
The timer allows the setting of a time from
which a countdown begins. This function does
not turn the oven on or off, but only sounds
an audible alarm when the time has elapsed.
X
X
Press the Mode or Set button once;
the display shows:
The bell symbol flashes, then the
alarm duration can be set with the
+ and – buttons. When this function
is active, the bell symbol remains lit
and the display shows the remaining
time (countdown).
At the end of the time an acoustic
signal (which can be stopped
by pressing Set) sounds.
Modifying/deleting data
X
X
The set data can be changed at any time
by pressing the + and - buttons together.
Note: The oven stays hot at around the set
cooking temperature for a long time after
it has been switched off; therefore to avoid
overcooking or burning the food, it is advisable
to remove it from the oven.

Switching on the first time

X
also remains lit.
goes off.

Suggestions

Z
Z
9 place them above the grills or drip-trays
Z
Z
Note: Before switching the oven on, read
the timer instructions (see page 11).
– 13 –
Cancelling the cooking duration
automatically ends the function,
and vice versa.
In case of programmed operation,
the appliance will not accept end
of cooking times prior to those of start
of cooking proposed by the appliance
itself.
X
When using the oven for the first time,
operate it empty with the temperature knob
set to maximum for at least 40 minutes and
airing the room.
The odour noticed during this
operation is due to the evaporation
of substances used to protect
the oven during the period between
manufacture and installation.
After the 40 minutes, the oven stops
automatically and will be ready for use
after cooling down the oven.
X
For successful cooking, never place your
dishes in the oven when it is cold; wait until
it has reached the set temperature.
X
During cooking, never place pots or
containers directly on the oven floor;
provided, on one of the 5 shelves available;
failure to do so could damage the oven
enamel.
X
Your Franke oven uses a special enamel
which is easy to keep clean, however
it is advisable to clean it frequently to avoid
baking on grime and previous cooking
residues.
X
Any self-cleaning panels (if provided)
can be cleaned with soap and water (see
cleaning instructions).
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido