Stanley Bostitch GF28WW Manual De Instrucciones página 8

a place where the temperature is less than 40°C.
© Stanley Bostitch
Do not abuse the cord. Never carry the charger by the
GB Not to be reproduced without permission. Unauthorised copies of this document do not constitute CE
cord or yank it to disconnect it from
compliance for the products.
●
the mains. Keep the cord away from
heat, oil and sharp edges.
FR Reproduction interdite sans permission préalable. Les copies non autorisées de ce document ne signifient en
● When the charger is not in use, or
rien que les produits soient conformes aux normes CE.
DE Vervielfältigung nicht ohne Genehmigung gestattet. Unzulässig erstellte Kopien dieses Dokuments erfüllen nicht
die CE-Richtlinien für Produkte.
● To avoid danger, always use only the specified
NL Mag niet worden vermenigvuldigd zonder toestemming. Onrechtmatige kopieën van dit document willen niet
charger.
zeggen dat de producten voldoen aan de CE-vereisten.
● To avoid personal injury, only use the accessories
DK Må ikke gengives uden tilladelse. Uautoriserede kopier af dette dokument udgør ikke CE overholdelse for
or attachments recommended in these handling
produkterne.
instructions or in the Stanley Bostitch catalogue.
● Check and confirm that the supply cord and housing
FI Ei saa jäljentää ilman lupaa. Tämän asiakirjan ilman valtuutusta tehdyt kopiot eivät muodosta tuotteille CE-
are not damaged before using the charger. If the
yhdenmukaisuutta.
supply cord of this charger or housing is damaged,
the charger must be returned to the Stanley
GR Απαγορεύεται η αναπαραγωγή χωρίς προηγούμενη άδεια. Τα μη εξουσιοδοτημένα αντίγραφα του παρόντος
Bostitch authorised service center for the cord or
εγγράφου δεν αποτελούν συμμόρφωση CE για τα προϊόντα.
housing to be replaced. Only the authorised service
center should do these repairs. Stanley Bostitch will
IT Vietata la riproduzione senza permesso. Le copie non autorizzate di questo documento non garantiscono la
not be responsible for any damages or injuries
conformità CE per i relativi prodotti.
caused by unauthorised persons attempting to
repair the tool, or mishandling of the tool.
NO Skal ikke reproduseres uten tillatelse. Ikke godkjente kopier av dette dokumentet oppfyller ikke kravene for CE-
● To ensure the designed operational integrity of the
merking for produktet.
power tool and charger, do not remove installed
covers or screws.
PT Reprodução proibida sem autorização prévia. As cópias não autorizadas deste documento não estão em
● Always use the charger at the voltage specified on
conformidade com a CE para os produtos.
the nameplate.
ES Prohibida la reproducción sin permiso. Las copias no autorizadas de este documento no suponen la
● Always charge the battery before use.
conformidad con las normas CE de los productos.
● Never use a battery other than that specified. Do not
connect a non-tool specific dry cell, or a
SE Prohibida la reproducción sin permiso. Las copias no autorizadas de este documento no suponen la
rechargeable battery other than that specified or a
conformidad con las normas CE de los productos.
car battery to the power tool.
PL Niniejszy dokument nie może być kopiowany bez pozwolenia. Nieautoryzowane kopie niniejszego dokumentu nie
● Do not use a transformer containing a booster.
stanowią deklaracji zgodności CE prezentowanych produktów.
● Do not charge the battery from an engine, electric
generator or DC power supply.
CZ Niniejszy dokument nie może być kopiowany bez pozwolenia. Nieautoryzowane kopie niniejszego dokumentu nie
stanowią deklaracji zgodności CE prezentowanych produktów.
ADDITIONAL SAFETY EQUIPMENT
EYE PROTECTION which provides protection against
SK Rozmnožovanie bez povolenia je zakázané. Neoprávnené kópie tohto dokumentu nie sú v súlade s CE pre dané
flying particles both from the FRONT and SIDE should
výrobky.
always be worn by the tool operator and others in the
work area when loading, operating or servicing this tool.
HU A dokumentum engedély nélkül nem sokszorosítható. Az engedély nélkül sokszorosított dokumentum nem jelenti
Eye protection is required to guard against flying
a termék CE-megfelelőségét.
fasteners and debris, which could cause severe eye
injury. The employer and/or user must ensure that proper
RO Reproducerea neautorizată este interzisă. Copiile neautorizate ale acestui document nu reprezintă
eye protection is worn.
conformitatea CE pentru produse.
when being maintained and
inspected, disconnect the power
cord of the charger from the
mains.
Eye protection in accordance with
89/686/EEC, and with equal or
greater grade than defined in EN166
should be used. However all aspects
of the operators work, environment
and other type/s of machinery being used should also be
considered when selecting any personal protection
equipment.
Note: Non-side shielded spectacles and face shields
alone do not provide adequate protection.
CAUTION: ADDITIONAL SAFETY PROTECTION may be
required in some environments. For
example, the working area may
include exposure to noise levels that
can lead to hearing damage. The
employer and user should ensure
that any necessary hearing protection is provided and
used by the operator and others in the work area. Some
environments will require the use of head protection
equipment. When required, the employer and user must
ensure that head protection is used.
SAFETY PRECAUTIONS – GAS TOOLS
●
Be careful of ignition
and explosions.
This tool must not be used in a
combustible environment or in the
presence of flammable liquids or
gases. This tool produces hot exhaust
gases that may ignite flammable
materials and produces sparks. Since
sparks may fly during nailing, it is dangerous to use
this tool near lacquer, paint, benzine, thinner,
gasoline, gas, adhesives and similar inflammable
substances, as they may ignite or explode. Under no
circumstances should this tool be used in the
vicinity of such inflammable material.
●
Explosion and fire hazard.
The fuel cell is an aerosol dispenser
with flammable contents. It is a
pressured
propellant will remain in the fuel cell.
Failure to follow instructions may
result in explosion or fire. Keep the
power tool, fuel cells and battery
away from sunshine and from temperatures
exceeding 50°C (120°F). The fuel cell and/or battery
may burst, releasing flammable gas. Do not pierce
or burn the container, even after use. Do not
incinerate, refill, reclaim or recycle the fuel cell. Do
not spray on to a naked flame or any incandescent
material.
container and the