Maintenance Of Thermal Cover; Special Maintenance; Winter Inactivity - Jacuzzi city spa Uso-Mantenimiento

1
3
2
2
1
4
1

Maintenance of thermal cover

Fabric
Remove the cover from the support frame and lay it on a
straight surface.
Dampen the fabric with clean water.
Evenly spread a diluted solution of neutral soap on the surface.
Let the solution stand for 2-3 minutes, depending on the
degree of dirtiness.
Clean the cover with a soft brush.
To remove all soap residue, rinse with plenty of clean water.
In case of heavy incrustation, repeat the operation.
If necessary, perform the steps above on the back side as well.
Let the cover dry. Then place it on its support until it is per-
fectly dry.
Leatherette
Use a neutral cleaner, then rinse with clean water.
If necessary, use a specific product after cleaning to restore
and maintain the material's shine.

SPECIAL MAINTENANCE

Winter inactivity

In areas where winter temperatures frequently drop below 0°C,
during periods in which the spa is not used, proceed as follows:
Turn off the power supply on the main panel.
Completely drain the spa via the drain valve, which is to be
left open, and the possible gate valve installed on the auxiliary
drain (if installed; refer to the pre-installation instructions).
The emptying of the spa is not complete; stagnant water on the
seats and bottom of the tub can be eliminated with a sponge, while
water left in the hoses can be sucked out through the hydromas-
sage and suction intakes, using a liquid-suction pump. It is advis-
able to empty the pump as well via the appropriate drain plug.
IMPORTANT
In cold climates, where temperatures drop well below 0°C,
all residual water should be eliminated from the circuit.
Remove and clean the filter cartridge and store in a dry place.
Cover the spa to keep it clean.
25