Saf-Fro DIGISTEEL 250C Manual De Instrucciones página 30

Load – restore data from the USB Device to
the machine memory.
Table 12 Load Menu
Symbol
Settings
Video
To load the data from the USB Memory:

Connect the USB to welding machine.

Add "USB Memory" icon to the Welding parameters
bar [52].

Use the right knob [44] to highlight the icon "USB
Memory".
Figure 32

Press the right knob [44] to get access to "Load" menu
– the load menu is shown on the display.
Figure 33

Press the right knob [44] to get access to "Settings"
menu – the Settings menu is shown on the display
Figure 34

Settings – this option allows you to load.
English
Description
Settings, – this option allows you to load
Current
Parameters
Programs stored in memory. To load one of
above:

Select file with the data to be loaded into machine. by
right knob [44].

Press the right knob [44] to confirm the file selection.

The display shows the data which can be loaded.
Use the right knob [44] to highlight the data icon.

Press the Right Knob [44] to confirm the data
selection.
26
Welding Settings, Advanced
Configuration or
Figure 35
Figure 36
Figure 37
Welding
English