TEUFELBERGER pulleySAVER Manual Del Usuario página 13

Ocultar thumbs Ver también para pulleySAVER:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 81
Use our equaLIZA as auxiliary equipment. There are two tech-
niques to install the equaLIZA link:
1. Compress the soft eye of the pulleySAVER and slide on
the green Anchor Ring of the equaLIZA (fig.11). Allow
the soft eye to spring back into position and retain the
equaLIZA link (fig. 12).
2. Remove both Prusik loops from the pulleySAVER rope.
Slide the green Anchor Ring of the equaLIZA over the tail
of the pulleySAVER and up to the soft eye. Reinstall both
Prusik loops in the correct relative positions. (fig. 13-16)
Note that the combined strength of the two anchors points is
used to create a single „virtual" anchor that can be adjusted
in length and will move as the climber changes work position.
fig. 11
fig. 14
WARNING: The angle between the rope sections around the upper anchor points may be 120°
maximum to limit the load exerted on the rope sections. When selecting anchor points, ensure
that the pulleySAVER will be retained in position during the full range of operation and that it
cannot move out of position unintentionally. During retrieval of the system the Pulley is pulled
through two Soft Eyes - the pulleySAVER and the equaLIZA.
fig. 12
fig. 15
MODES OF USE
fig. 10
fig. 13
fig. 16
13

Publicidad

Tabla de contenido
loading

Tabla de contenido