Ocultar thumbs Ver también para pulleySAVER:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 81
EXPLANATION OF LABEL NOMENCLATURE
Product name
EN 795B: Standard for transportable, temporarily mounted anchor device, protection against
falls from a height
ANSI Z133-2017: US-american standard for arboricultural operations
AS/NZS5532:2013: rating: single person / limited freefall ... Australian/New Zealand standard
for anchor devices, class: single person / work positioning / restraint system
L:
Length in [m]
Ser. Nr.:
Year/month of manufacture - serial number
CE 0408
The CE mark certifies compliance with the fundamental requirements of regulation
(EU) 2016/425. The number identifies the testing institute (e.g., 0408 for TÜV
Austria Services GmbH, Deutschstrasse 10, A-1230 Vienna, Austria).
α Max. 120°: Indication that the angle between the rope sections around the anchor
points may be 120° maximum.
Manufacturer
Indication informing the user that it is necessary to read the instructions for use
„single user only"
"personnel attachment only"
BMP 695852
The European standard symbols for washing of textiles and their care are used.

USE

Note: For operating parameters also consult the specific user instructions for all hardware that
is part of the pulleySAVER, i.e. DMM PINTO Pulley.
This anchor device was tested to EN 795, Class B, for use by a single person using
personal protective equipment.
Pursuant to EN 795, this anchor device (anchor point) for personal protection equipment
must be capable of withstanding a force of 18 kN in every described mode of use when
new.
This assembly is intended for use in a work positioning system. It shall not be used for fall
arrest applications. Under no circumstances shall the potential fall distance exceed
500mm.
Whenever possible, the anchor point should be vertically above the user. The potential for,
and consequences of pendulum swings shall be managed at all times.
Check the structure to which you fasten the anchor device as to whether or not it is of
suitable and sufficient strength for the purposes of supporting any foreseeable loading in
cluding that in an emergency contingency. Prior to using it have the anchor device checked
by a competent person. The product can be used as a belay for the rescuer after a single
fall – this must only be done if a suitable structural anchor (tree / branch) is chosen. The
structural anchor (tree / branch) must withstand more than 12 kN.
Always attune the length of the anchor device to the object it is installed around.
indication informing the user that the anchor divice must only
be used by a single user.
only for personal fall protection purposes
license number - identifies certification to AS/NZS
USE
9

Publicidad

Tabla de contenido
loading

Tabla de contenido