Radial Intercom System With Telephones - Fermax MDS CITY Manual Del Funcionamiento

3.2. Radial Intercom system with Telephones

The functionallity of the "hotkeys" keypad is:
Po Guard - Telephone
Communicates the guard with a particular telephone. Follow these steps:
1. Dial the telephone number. If the telephone to communicate to coincides
with the last one in communication, it is not necessary to dial its number
again.
2. Dial the Po
3. The display will show the telephone number dialed. I.e., when calling
telephone 2001 the display will show: [Po/ 2001].
If the number dialed does not exist, the display will show: 'Code not valid'.
Telephone - Telephone Communication
Allows to communicate two telephones in the installattion. To do it:
1. Dial the number of the first telephone.
2. Press the Po
3. Press the
4. Dial the second telephone number.
5. Press the " " key to generate the call to that telephone.
This step sets communication between both telephones. The display will show
both numbers indicating that they are "connected".
RESET Key
The RESET key is the one located below the door release button (
Pressing this key will set all the telephones in stand-by.
key to select this communication channel.
key to communicate with itself.
key. The guard unit will ask for the second telephone number.
).
Pag 25