Camp Safety DRUID Manual Del Usuario página 30

Presence of permanent deformations on any component,
Ÿ
Unauthorised modification to the product (welding, drilling, etc.),
Ÿ
Corrosion that severely affects the surface state of the metal which does not disappear after slight rubbing with emery paper,
Ÿ
Malfunction of the mechanisms of the actuating lever [4], the connecting lever [7], the movable cam [6].
Ÿ
Burrs and/or sharp edges on any surfaces that could come in contact with the rope; especially on the movable cam [6],
Ÿ
the fixed cam [5], the front plate [2], and the rear plate [1],
significant wear on any part of the device (>1mm),
Ÿ
breakage or loss of the mechanism cover [8].
Ÿ
Any product or component showing any defect or wear, or if in doubt, should be withdrawn from service immediately. Each
product in the safety system can be damaged during a fall and must be always inspected before use it again. Do not
continue to use a product after a major fall because a damage may have occurred, even no external signs are visible.
LIFETIME
The lifetime of the product is unlimited, unless any defect appears and provided that periodic inspections are made at
least once every 12 months from the date the product is first used and the results are recorded in the life sheet of the
product. The following factors can reduce the lifetime of the product: intense use, damage to components of the product,
contact with chemical substances, high temperatures, tears and abrasions, violent impacts, failure to maintain as
recommended. When suspect that the product is no more safety and reliable, please contact C.A.M.P. spa or the
distributor.
TRANSPORTATION
Protect the product from risks such as those detailed above.
28