Bosch 3KLIFTTABLE Instrucciones De Operación página 11

Operating The Lift To Remove Components
1. Always follow the vehicle manufacturer's recommended service procedure for removal of the
component.
2. Raise the vehicle above the height of the lift table.
3. Attach the required accessories to the platform and to the vehicle component.
4. Position the Lift under the vehicle. Adjust Lift handle and pump supports if the load extends over
platform limiting access to handle or pump. Connect the air hose to the air pump.
5. Press the end of air pump foot pedal marked
vibrate when pressed. This is normal and present no danger.
6. Remove any remaining bolts from the vehicle component.
7. Press the end of the air pump foot pedal marked
pressure from the safety latch. Squeeze the safety release lever. Press and hold the end of the air
pump foot pedal marked
WARNING: To prevent personal injury and/or equipment damage,
● Keep all body parts clear of the Lift when safety latch has been disengaged.
8. Ensure that the pathway of Lift is level, sturdy and free of obstructions.
WARNING: The Mobile Lift Table could roll down slopes and ramps by itself. The Mobile Lift
Table is heavy and therefore has a longer braking distance. Handling the Mobile Lift Table on
slopes and ramps carelessly could cause serious personal injuries or severe damage to materials.
● Do not move Lift while a load is raised. Move the Lift with loads on it only when the
platforms are in the lowest possible position and on hard, level surface. Do not move
the Mobile Lift Table over slopes above 2.0 degrees with a load and 3.5 degrees
without a load.
● Move the Mobile Lift Table in the direction of the slope, not across it.
● Position the vehicle part on the Mobile Lift Table to minimize how much of the vehicle
part hangs over the edges of the platforms and so that the path is clearly visible.
● Personnel must remain above the Mobile Lift Table on slopes.
● Do not move the Mobile Lift Table at a speed faster than 3 ft/sec. Do not stand in front
of load when moving.
● Use the Lift only with the help of an assistant to control its movements.
● Prevent the Mobile Lift Table from rolling by engaging rolling brakes.
9. Move the Lift and load out from under the vehicle.
WARNING: The load could tip or fall if the accessories have not been attached to the lifting
equipment correctly or if the load has not been attached to the accessories correctly. This could
result in serious personal injuries or severe damage to components/equipment.
● Ensure that the accessories have been secured to the lifting equipment correctly.
● Ensure that the load has been secured to the accessories correctly.
Operating The Lift To Install Components
1. Position the Lift with the component under the vehicle chassis. Connect the air hose to the air pump.
2. Align the component in the correct position and press the end of the air pump foot pedal marked
to raise the lift.
3. Always follow the vehicle manufacturer's recommended service procedure for installing the component.
OPERATING INSTRUCTIONS
and lower the lift completely.
© Bosch Automotive Service Solutions Inc.
to raise the lift to the load. Note: Pedal may briefly
to raise the lift platform slightly to remove
Page 11 of 20
SP04513059 Rev A