Bosch 3KLIFTTABLE Instrucciones De Operación página 9

Platform Sliding Extension Feature
Retract spring plunger and pull on the underside of table (See Figure 6) to extend sliding platform to
increase the surface area of the platform. To ensure a secure work surface, release the spring plunger
and slide platform extension until it locks into one of the three stop positions. Note: If the sliding platform
binds, adjustment screws may need to be turned. See Figure 7.
Secure components to the platform with bolts and/or straps. Many M10 x 1.5 holes are provided in the
platform top to thread bolts into. CAUTION: To prevent damaging threads in the platform, do not
torque bolts beyond 50 ft. lbs. (68 N•m). Holes in the side edges of the platform are provided for
securing straps. See Figures 7 and 8.
WARNING: To prevent personal injury and/or equipment damage,
● Always secure components to the platform with bolts, chains and/or straps. Select suitable
restraints and holding fixtures for the shape of the vehicle part and in accordance with the
specifications of the automobile manufacturer's workshop manual.
● Ensure spring plunger is locked into one of the three stop positions.
● Do not exceed 1540 lb (700 kg) on the extendable platform.
Spring Plunger
Stop Positions
Platform Mounting Holes (M10 x 1.5)
to secure components See Figure 7.
Adjustment
Screw
MOBILE LIFT FEATURES
Spring
Plunger
Figure 6
Figure 7
© Bosch Automotive Service Solutions Inc.
(continued)
Figure 8
Platform
.25 in. MAX
.25 in MAX
6.4 mm MAX
(6.4 mm) MAX
Platform Mounting Hole Screws
Mounting hole screws must be tightened securely
to holding fixtures or platform. Screws must not
extend below the platform more than .25 in(6.4 mm)
to avoid interfering with platform movement.
Holes for straps
Holding Fixture
.25 in. MAX
.25 in MAX
6.4 mm MAX
(6.4 mm) MAX
Page 9 of 20
SP04513059 Rev A