Inspection And Maintenance; Preventive Maintenance - Bosch 3KLIFTTABLE Instrucciones De Operación

WARNING: To prevent personal injury,
•
Only qualified personnel shall perform inspections and repairs to this Lift.
•
Before each use, inspect the Lift for bends, cracks, dents, elongated holes, or missing hardware.
If damage is found, discontinue use.
•
Use only those repair parts called out in the parts list in this document. Items found in the parts
list have been carefully tested and selected.
Inspection
Before each use, an approved inspector must inspect the Lift for bends, cracks, dents, elongated holes, or
missing hardware. If damage is found, discontinue use.
Repair
When repairing the Lift, use only those repair parts called out in the parts list in this document. Items
found in the parts list have been carefully tested and selected.
Disposal
At the end of the useful life of the Lift, dispose of the components according to all state, federal, and local
regulations.

Preventive Maintenance

NOTE: 1 cycle = 1 complete raising and lowering of the Lift platform.
Every 300 cycles or 6 months, whichever comes first:
A. Hydraulic Cylinders
1. Inspect for hydraulic fluid leaks.
● Some oil accumulation on cylinder rod is normal and desired for proper function of the unit.
● If fluid is escaping and puddling on the floor, the cylinder requires servicing.
2. Without load applied to platform, raise and lower Lift multiple times. If cylinders pulse, stick, or
generally do not operate smoothly, unit needs servicing.
B. Hydraulic Fittings
1. Inspect for leaks.
● Tighten fittings to stop leak.
● Replace fittings if tightening does not stop leak.
C. Hose
1. Inspect and replace if found to contain cuts, cracks, or considerable surface wear.
D. Pump
1. Check hydraulic fluid level.
● The fluid level should be 1/2 inch (12.7 mm) from the filler/vent cap with cylinder retracted.
Replenish with hydraulic fluid (P/N 9637) through this port if needed.
2. Check pump reservoir for leaks due to damage to reservoir.
3. Raise and lower platform by operating air pump pedal. Ensure platform raises and lowers only
when the air pump pedal is actuated.
WARNING: To prevent personal injury and/or equipment damage, discontinue use and service
the unit immediately if platform moves after air pump pedal is released.
Page 12 of 20
SP04513059 Rev A

INSPECTION AND MAINTENANCE

© Bosch Automotive Service Solutions Inc.