Functional Checks - Bosch 3KLIFTTABLE Instrucciones De Operación

Lift Operation and Safety Latch Mechanism
Without external load applied to lift platform, fully raise and lower multiple times to ensure proper function
of the hydraulic system and scissor components.
1. Press the end of the air pump foot pedal marked
extension. Lower the Lift platform and ensure the descent is automatically interrupted by the safety latch
mechanism.
2. Press the end of the air pump foot pedal marked
from the safety latch. Squeeze the safety release lever. Press and hold the end of the air pump foot pedal
marked to lower the lift platform until it reaches full collapse.
3. Ensure platform raises and lowers only when the air pump foot pedal is actively depressed by the operator.
WARNING: To prevent personal injury and/or equipment damage
● Keep all body parts clear of the Lift when safety latch has been disengaged. If
platform moves after air pump pedal is released, discontinue use and service
immediately.
Functional Check of Other Features
A. Platform Tilting Features
1. Turn forcing screws in/out fully to ensure proper function of platform tilting feature. See Figure 4
of "Fine Adjustment Tilting Feature" section.
B. Platform Sliding Extension Feature
1. Retract spring plunger and extend platform. Ensure spring plunger engages at all three stop
positions when the plunger is released.
Fine Adjustment Tilting Feature
The forcing screws shown in Figure 5 allow the user to finely tilt the platform to help remove or install vehicle
components and compensate for uneven shop floors, difficult fastener locations, etc. The forcing screws can
be operated by either hand, or wrench or socket, depending on the applied load.
WARNING: To prevent personal injury and/or equipment damage,
● To prevent tipping, angled loads on the platform MUST NOT be more than 2 degrees.
● To prevent tipping, ensure the load is centered on lift table and distributed evenly.
● Place the vehicle part on the lift table so that it is flat.
Forcing
Screws
Page 8 of 20
SP04513059 Rev A

FUNCTIONAL CHECKS

to raise the lift platform until it stops at maximum
to raise the lift platform slightly to remove pressure
MOBILE LIFT FEATURES
Figure 5
© Bosch Automotive Service Solutions Inc.