Preparation And Set Up - Bosch 3KLIFTTABLE Instrucciones De Operación

Unpackaging
1. Cut away stretch wrap and discard.
2. Ensure the Mobile Lift Table is complete and inspect for visible damage, such as bends, cracks,
dents, or damage to threaded holes in the platforms. Do not use the product if damaged or in poor
condition, but take it out of operation immediately and call Technical Services.
3. Cut plastic shipping banding to free carton from platform. Set carton aside.
4. Cut metal shipping banding to free Mobile Lift Table from wood pallet.
5. Raise the Mobile Lift Table minimum 10 in [250 mm] off the wood pallet using a fork lift, 2-Post Vehicle
Lift, or other equipment capable of
a. Lifting 1200 lb
b. Maintaining points of contact within the 4 lifting zones at all times. See Figure 1.
4 in
WARNING: To prevent personal injury and/or equipment damage, do not roll Mobile Lift
Table off the wood pallet and onto floor.
6. Slide wood pallet out from under the elevated Mobile Lift Table and discard.
7. Lower the Mobile Lift Table until all four caster wheels contact the floor and fully support the weight of
the product.
8. Open the carton and locate the Push Handle and its 4 mounting screws. Install the handle by
inserting into the Base Frame. Thread mounting screws into holes and through aligning holes in the
Push Handle until screws are snug against the inside wall of the Push Handle tubing. Torque screws
to 15 ft-lb (20 N•m). See Figure 10.

PREPARATION AND SET UP

1
3
14 in
Lifting
Zone
© Bosch Automotive Service Solutions Inc.
Figure 1
2
4
Page 5 of 20
SP04513059 Rev A