English
Bosch Power Tec GmbH
5.3
Optional: Connect the irradiation
and temperature sensor
Materials required
Slotted screwdriver
Split ferrite with spanner (included in the scope of
delivery)
Cable ties (included in the scope of delivery)
If you want to extend the CAN cable to which the
irradiation and temperature sensor is connected,
please note:
Recommended cable type: RD-Y(St)Y GR 4 × 2 × 0.5
2
mm
Maximum cable length: 100 m
Maximum cable cross-section: 0.75 mm
Jacket: Weather- and UV-resistant, and suitable for
earthing
▶
Procedure
1. Ensure that the irradiation and temperature sensor
is aligned and installed parallel to the surface of
the solar module.
2. If required, fit the end of the wire with a cable end
sleeve.
Electrical installation | 31
2
BPT-M Touch | Installation manual