Storing The Tool; Troubleshooting; Maintenance; Routine Maintenance - CAMPAGNOLA T-CAT Manual De Uso

Storing the tool

In case of long periods of tool inactivity:
• Follow all the maintenance indications in the manual.
• Remove the cutting residues (sawdust) from the front cover (5).
• Perfectly clean and re-assemble the tool.
• Put the bar (2) into its guard (15).
• Recharge the batteries before putting them into the carton box.
• Clean the tool and put it with its components into its carton box.
• Store the tool in a dry place.
• During long periods of inactivity recharge the batteries not later than every 3 months.

Troubleshooting

WARNING!
All the following maintenance operations shall be carried out by a maintenance technician.
FAULT POSSIBLE CAUSE
Flat battery
The tool does not
work.
Disconnected battery
Possible electronic or mechanic problem
The battery is flat
The chain is not sharp
The tool cutting
strength decreases
The chain is too tensioned
Scarce lubrication
The chain is not tensioned enough
The chain stops.
Scarce lubrication
Worn chain
The chain skips
while cutting.
Damaged chain
Damaged battery.
The battery does
Faulty battery charger.
not get completely
recharged.
Unsuitable battery charger.
WARNING!
Neglecting to follow the instructions in the manual could cause damages or injuries.

6 MAINTENANCE

Routine maintenance

WARNING!
Before carrying out any routine maintenance operation, put the ON/OFF button (11) in 'off' position and
•
remove the battery (16) from the tool.
• All the maintenance operations which are not mentioned in this manual must be carried out at an Authorized
Service Point.
Routine maintenance operations can be carried out by the operators.
6.1.1

Chain tension adjustment

The chain (1) tends to expand or shrink while using the tool. This causes a change in its tension.
Periodically check the chain tension, adjusting it if necessary.
Do not tension the chain when it has stretched due to heat. Make any new adjustment only after its cooling.
Use and maintenance manual – Translation of
original Instruction.: 00, Date 30/08/2021
REMEDY
Recharge the battery (16)
Check the proper connection of the battery (16) to
the tool
Take the tool to an Authorized Service Point.
Recharge the battery (16)
Sharpen or replace the chain (1)
Regulate the chain (1) tension
Lubricate the chain (1)
Regulate the chain (1) tension
Lubricate the chain (1)
Sharpen the chain (1)
Replace the chain (1)
Replace the battery (16)
Replace the battery charger (18)
Check that the battery charger (18) is the one
supplied with the tool.
Page 33