Stopping The Tool; Battery Charging - CAMPAGNOLA T-CAT Manual De Uso

WARNING!
If the chain (1) is not lubricated enough, it can seize.
WARNING!
Do not use any recycled oil. Use only a specific chain lubricating oil.

Stopping the tool

• Release the operating lever (7);
• Switch off the tool by means of the ON/OFF button (10);
• Remove the battery (16) by pressing the releasing plates (17).
WARNING!
Never put the tool onto the ground before the chain (1) has stopped its movement
WARNING!
Let the chain (1) and bar (2) cool for a few minutes before checking the chain (1) tension.

Battery charging

1) Place the battery charger (18) flat on a table, plug in the batteries (16) and connect the power supply cable (20).
2) Insert the charger plug into the mains socket, avoiding the use of electric extension cables, as they are a potential
source of electrical risks.
3) The LED indicators (19) of the charger (18) become red while the battery is charging. When the battery reaches
the maximum charge level, the LED indicator (19) on the corresponding battery side becomes green. The recharge
of the two batteries, if they are both connected, occurs simultaneously.
When just one battery is recharging, the LED indicator on the free side is green.
Page. 30 Use and maintenance manual – Translation of
original Instruction.: 00, Date 30/08/2021