Maintenance; Warranty - oventrop TRV9 Manual De Instrucciones

Limitation
(for instance between figure "2" and "4")
1. Slide the limiting clips out of the
"parking position" (between figure "5"
and "0", illustr. 6) with the help of a
suitable tool or pin.
Illustr. 6
2. To limit the minimum control range, one
limiting clip should be fitted into the
groove immediately before figure "2"
(illustr. 7).
Illustr. 7
3. To limit the maximum control range, the
second limiting clip should be fitted into
the groove immediately after figure "4"
(illustr. 8).
Illustr. 8
16
Locking
(for instance to position "3")
1. Set the thermostat to position "3".
2. Slide the limiting clips out of the
"parking position" and push them into
the grooves immediately before and
after figure "3" (illustr. 9).
Illustr. 9
The limitation and locking can be cancelled
at any time by sliding the limiting clips out
of the grooves and by fitting them back into
the "parking position".

7 Maintenance

The components
maintenancefree.

8 Warranty

Oventrops warranty conditions valid at the
time of supply are applicable.
of the set are