Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
Troubleshooting
Steam is coming from the oven
When cooking foods with a high water
content (e.g. oven chips) there may be
some steam visible at the rear grille.
Take care when opening the oven
door, as there may be a momentary
puff of steam when the oven door is
opened. Stand well back and allow any
steam to disperse.
The oven fan is noisy
The note of the oven fan may change
as the oven heats up - this is perfectly
normal.
The knobs get hot when I use
the oven or the grill, can I avoid
this?
Yes, this is caused by heat rising from
the oven or the grill, and heating them
up. Don't leave the oven door open.
Make sure that the grill pan is pushed
right back to the 'backstop' when grill-
ing.
If there is an installation
problem and I don't get my
original installer to come back
to fix it who pays?
You do. Service organisations will
charge for their call outs if they are cor-
recting work carried out by your origi-
nal installer. It's in your interest to track
down your original installer.
Current Operated Earth Leakage
Breakers
Where the cooker installation is pro-
tected by a 30-milliamp sensitivity re-
sidual current device (RCD), the com-
bined use of your cooker and other do-
mestic appliances may occasionally
cause nuisance tripping. In these in-
stances the cooker circuit may need to
be protected by fitting 100mA device.
This work should be carried out by a
qualified electrician.
Food is cooking too slowly, too
quickly, or burning
Cooking times may differ from your
previous oven. Individual tastes may
require the temperature to be altered
either way, to get the results you want.
Try cooking at a higher temperature
setting. Is the oven roof in?
The oven is not cooking evenly
Do not use a tin or tray larger than
320mm x 305mm.
If you are cooking a large item, be pre-
pared to turn it round during cooking.
If two shelves are used, check that
space has been left for the heat to cir-
culate. When a baking tray is put into
the oven, make sure it is placed cen-
trally on the shelf.
Check that the door seal is not dam-
aged and that the door catch is ad-
justed so that the door is held firmly
against the seal.
A dish of water when placed on the
shelf should be the same depth all
over. (For example, if it is deeper at
the back, then the back of the cooker
should be raised up or the front low-
ered). If the cooker is not level ar-
range for your supplier to level it for
you.
Oven not coming on when
turned on manually
If using the Multi-function oven have
you set a cooking function?
Is the power on? Is the clock illumi-
nated?
If not there may be something wrong
with the power supply. Is the cooker
supply on at the isolator switch?
If this does not solve the problem
contact a service person.
Oven not coming on when
automatic cooking
Timer set correctly but oven knob left
OFF by mistake?
If using the Multi-function oven have
you set a cooking function?
Oven temperature getting hotter
as the cooker gets older
If turning the knob down has not
worked or only worked for a short
time then you may need a new ther-
mostat. This should be fitted by a
service person.
Grill not cooking properly
Are you using the pan and trivet sup-
plied with the cooker? Is the pan be-
ing used on the runners, not the floor
of the compartment? Is the grill tray
pushed fully back to the stop?
The oven light is not working
The bulb has probably blown. You
can buy a replacement bulb (which is
not covered under the guarantee)
from a good electrical shop. Ask for
an Edison screw fitting 15w 240v
lamp, FOR OVENS. It must be a spe-
cial bulb, heat resistant to 300 °C.
34
Open the oven door and remove the
Handyrack
(if
fitted)
shelves.
Turn off the power supply.
Unscrew the bulb cover by turning
anticlockwise. Unscrew the old bulb.
Screw in the new bulb, screw back
the bulb cover. Turn on the electricity
supply and check that the bulb now
lights.
Hotplate ignition or hotplate
burners faulty
Is the power on? Is the clock illumi-
nated? If not there maybe something
wrong with the power supply.
Are the sparker (ignition electrode) or
burner slots blocked by debris?
Are the burner caps correctly lo-
cated?
Hotplate burners will not light
If only one or all the hotplate burners
will not light, make sure that the parts
have been replaced correctly after
wiping or removing for cleaning.
Check that there is not a problem with
your gas supply. You can do this by
making sure that other gas appli-
ances you may have are working.
Do the burners spark when you push
the button? If not check the power is
on - is the clock illuminated?
General Safety
Instructions
This appliance must be installed by a
competent person in accordance with
the installation instructions. The in-
stallation must comply with the rel-
evant regulations and also the local
electricity supply company require-
ments
If you smell gas
Don't turn electric switches on or
off.
Don't smoke
Don't use naked flames
Do turn off the gas at the meter or
cylinder
Do open doors and windows to get
rid of the gas
Call your gas supplier.
This appliance is designed for do-
mestic cooking only. Use for any
other purpose could invalidate any
warranty or liability claim.
and
oven
Publicidad
Tabla de contenido
